Skip to content

AC Installation in Moraga, CA

Serving Moraga and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (650) 668-0834

The short answer

For most Moraga homes, a good AC installation starts with a room-by-room load calculation and a choice between central air and a heat pump. If your gas furnace is aging, a heat pump can handle both cooling and heating. That matters because Bay Area Air District rules will require gas furnaces manufactured from 2029 to meet a zero-NOx standard.

Adding or replacing air conditioning in a Moraga home involves more than picking a unit. The right system depends on your home's size, insulation, ductwork, and electrical panel, and on how you plan to heat the house in the years ahead. ExpertFlow HVAC Repair Service installs central air conditioners, heat pumps, and ductless systems for homeowners in Moraga's 94556 and 94575 ZIP codes. We're based in Pleasanton, about 18 miles southeast of Moraga, and we work throughout Contra Costa County. Here's how we approach an AC installation and what to consider before you decide.

Sizing an AC System for Your Moraga Home

An air conditioner that's too large cools the house quickly but shuts off before it removes much humidity, and it cycles on and off more often than it should. One that's too small runs constantly on hot afternoons and still can't keep up. Neither is comfortable, and both wear out equipment sooner.

We size systems with a room-by-room load calculation, not a rule of thumb based on square footage. The calculation accounts for details that vary a lot from house to house: which way the windows face, how much afternoon sun hits each side of the house, attic insulation, ceiling height, and whether rooms sit over a garage or crawlspace. On a hillside lot, one side of a house can get far more sun than the other, so we look at the whole home, not just the area around the thermostat.

Central AC or Heat Pump?

If you have a gas furnace and want cooling, you can add a standard central air conditioner that shares the furnace's blower and ductwork. You can also install a heat pump, which uses the same outdoor unit to cool in summer and heat in winter.

The choice often depends on the age of your furnace. Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. The rule doesn't require you to remove working equipment. It applies only when an existing furnace fails or is replaced.

If your furnace is fairly new, a central AC may be the simpler choice. If it's older and likely to need replacement in the next few years, installing a heat pump now covers both cooling and heating and saves you a second project later. We'll walk you through both options and what each involves for your house.

Homes Without Ductwork

Some Moraga homes were built with wall heaters, floor furnaces, or radiant heat and have no ducts at all. Others have ducts that are undersized, leaky, or routed through tight crawlspaces. Adding cooling to these homes usually follows one of these paths:

We'll also check your electrical panel. A home that has never had air conditioning sometimes needs a new circuit or a panel upgrade to support an AC or heat pump, and it's better to know that before the installation date.

  • Ductless mini-split heat pumps: an outdoor unit connected to wall-mounted or ceiling heads in individual rooms
  • New ductwork run through the attic or crawlspace, where there's enough room to do it well
  • Repairing, sealing, or resizing existing ducts so a new central system can deliver air where it's needed

What to Expect on Installation Day

Once you've chosen a system, the work typically goes like this:

Air conditioner and heat pump installations generally require a building permit and an inspection. We'll explain how that fits into your schedule when we plan the job.

  • We confirm the equipment, the outdoor unit location, and the thermostat placement with you before work begins
  • We remove any old equipment and properly recover its refrigerant
  • We set the outdoor unit on a level pad, with attention to clearances, noise toward bedrooms and neighbors, and access for future service
  • We install and test the refrigerant lines, condensate drainage, and electrical connections
  • We start the system, check airflow and refrigerant charge, and show you how to use the thermostat and change the filter

Rebates and Tax Credits in 2026

The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date, so it won't apply to a system installed now.

Local programs may still help. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before including it in any quote.

More services in Moraga

Related

What to expect

How a visit goes

  1. Diagnose First

    We test and inspect the system to find what's actually causing the problem, so you aren't paying to replace parts that were working fine.

  2. Explain Your Options

    You'll hear what we found and the realistic choices, whether that's a repair, a replacement, or simply keeping an eye on it, before we start any work.

  3. Fit the System to the House

    For new installations, we look at your home's layout, ductwork, and how you use each room so the equipment matches the space it has to heat and cool.

FAQ

Common questions

How long does an AC installation take in a Moraga home?

A straightforward replacement that uses existing ductwork is often finished in a day. Jobs that involve new ducts, ductless heads in several rooms, or electrical upgrades take longer. We'll give you a timeline after we've seen the home.

Do I have to replace my gas furnace because of the new Air District rules?

No. The Bay Area Air District appliance rules don't require you to replace working equipment. They apply only when an existing furnace fails or is replaced. For furnaces manufactured from 2029, the zero-NOx standard generally points toward a heat pump.

Can I still get the federal tax credit for a heat pump?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and it isn't available for installations after that date. Check BayREN and your local clean energy provider for current incentives.

Is a ductless system a good choice for an older home?

Often, yes. If your home has no ducts, or the ducts are in poor shape and hard to reach, a ductless mini-split can cool individual rooms without major construction. We'll compare it with adding ductwork so you can decide.

How do you decide what size system I need?

We run a room-by-room load calculation that considers insulation, window orientation, sun exposure, ceiling height, and layout. We don't size systems by square footage alone, because two homes of the same size can need very different equipment.

Do you install air conditioning outside Moraga?

Yes. Along with Moraga, we install AC and heat pump systems in Walnut Creek, Danville, San Ramon, San Leandro, and Hayward.

Need Heating or Cooling Help?

Tell us what's going on with your system, and we'll set up a visit to find the cause and walk you through your options.

Call (650) 668-0834 Request Service