The short answer
A heat pump replaces both your furnace and air conditioner with one electric system that heats and cools. In Moraga, a good installation starts with proper sizing and checks of your ductwork and electrical panel. Bay Area rules don't force you to replace a working furnace, but they make a heat pump the likely path once your gas furnace needs replacing after 2029.
Moraga homeowners usually start looking at heat pumps for one of a few reasons: an aging gas furnace, an air conditioner near the end of its life, or a plan to move the house toward all-electric. ExpertFlow HVAC Repair Service installs heat pumps in homes throughout Moraga, in ZIP codes 94556 and 94575, about 18 miles northwest of our base in Pleasanton. This page covers what a heat pump installation involves for a Moraga home, how the Bay Area's furnace rules affect timing, and what to check on incentives before you commit.
Why Moraga Homeowners Are Choosing Heat Pumps
A heat pump moves heat instead of burning fuel. In summer it pulls heat out of the house like an air conditioner. In winter it reverses and brings heat in. Moraga sits inland, east of the hills, so many homes need real cooling on summer afternoons and steady heat on cold winter nights. One system that handles both can replace the separate furnace and AC that many local homes have now.
Timing also matters. Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date. The rule does not require you to replace working equipment. It applies only when your existing furnace fails or you choose to replace it. If your furnace is older, planning now can keep you from making a rushed decision during a winter breakdown.
What We Check Before Recommending a System
A heat pump that is too large or too small will run poorly and cost more to operate. Before we recommend equipment, we look at how your specific house gains and loses heat. Moraga has a mix of older ranch homes, hillside houses and newer construction, and each one brings different questions.
- Room-by-room heating and cooling load, based on insulation, windows, sun exposure and square footage
- Condition, size and sealing of existing ductwork, including runs in attics and crawl spaces
- Electrical panel capacity and whether a new circuit or panel work is needed
- Outdoor unit placement, with attention to sloped lots, neighbor setbacks, noise and airflow
- Whether ductless units make more sense for additions, converted garages or rooms the ducts don't reach well
- Thermostat compatibility and whether to keep a gas furnace as backup heat (a dual-fuel setup)
How a Heat Pump Installation Works
Once you choose a system, we schedule the work and explain each step before we start. Most whole-home replacements follow the same general order, though older homes or panel upgrades can add steps.
We'll tell you up front if any part of the job needs a permit or a separate electrical appointment, so you aren't surprised partway through.
- Remove the old furnace, air conditioner or both, and handle disposal
- Set the indoor air handler and the outdoor unit on a proper pad or bracket
- Run refrigerant lines, the condensate drain and electrical connections
- Seal or adjust ductwork where we found leaks or airflow problems
- Install and set up the thermostat, then test the system in both heating and cooling modes
- Walk you through operation, filter changes and what normal heat pump behavior looks like
Incentives and Tax Credits: What's Current
The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations after that date, so don't plan on it for a project now.
Local programs may still help. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before including it in a quote.
If you're also thinking about a heat pump water heater, check the rules first. Under Rule 9-6, the zero-NOx date for small water heaters was set for 2027. The Air District Board is considering amendments in November 2026 that could delay it, so confirm the current rule before planning that replacement.
Serving Moraga and Nearby Communities
We install heat pumps across Moraga and in nearby Walnut Creek, Danville, San Ramon, San Leandro and Hayward. If you're comparing options or your furnace is showing its age, we can visit your home, look at your current setup and give you a clear recommendation, whether that's a full heat pump system, a dual-fuel setup or waiting until replacement makes sense.

